Safety Cord Type 2
The Safety Cord should be used in all applications of Type 2 Button-fix where extra safety is required.
On a vertical panel install two Safety Cords, one to each Fix in the top corners. An additional Button is required to capture the loop on the Safety Cord. To remove the panel completely, ease the loop on the Safety Cord off the Button.
Button-fix Features Guide.
 |
 |
 |
 |
|
| Features of the Fix | Type 1 | Type 1 Flush | Type 1 Bonded | Type 2 |
|---|---|---|---|---|
| Connects face-to-face | ||||
| Connects at 90° | ||||
| Drop down or sideways engagement | ||||
| Push-on engagement | ||||
| Suitable for ceiling panels | ||||
| Surface-mounted | ||||
| Semi-rebated/recessed | ||||
| Fully rebated/recessed | ||||
| Attached with screws | ||||
| Bonded | ||||
| Minimum panel thickness | 10mm (1) | 18mm (2) | No restriction | 10mm (1) |
| Marker accessories (available separately) | ||||
| Router multijig (available separately) | ||||
| Multilingual instructions on the website | ||||
| Independent load test reports (3) | ||||
| 2d DXF downloads on the website | ||||
| 3d CAD files available on request |
- (1) 10mm minimum with Varianta/Euro screws; 15mm minimum with wood screws
- (2) Minimum panel thickness 28mm when rebating into the edge of the panel
- (3) Type 1 Bonded test reports for specific adhesive/substrate combinations only
Other Products
Type 2
Connects panels at 90 degrees and engages with a straight push. Ideal for panels with no clearance above or at the side and applications where the emphasis is on ease of access.
More
Fix marker Type 2
The Fix marker helps with the quick and accurate installation of Type 2 Button-fix, reducing the need for measuring and marking out.
More
Type 1
Connects parallel panels where the emphasis is on strength. Highly versatile, it can be surface-mounted or semi-rebated into the panel, orientated for vertical or sideways assembly.
More
Type 1 Flush
For applications where panel-to-panel contact is required. It fits a simple oval rebate and can be rebated into the edge of a panel of at least 28mm thick or the face of a panel of at least 18mm thick.
More
